I just bought SoundID Reference and am already impressed with the result. Thank you.
Despite there being an article saying that it only supports a .1 (single, daisy chained) subwoofer, my setup is different:
Scarlett 18i20 Interface -> CMC2 controller -> 2x Focal Be6, Subwoofer A and Subwoofer B.
Each Subwoofer is on a different CMC2 output. There is no option to daisy chain them to the focal monitors.
In addition, due to selective mode cancellation, Subwoofer A is at ear height on the left of listening position. Subwoofer B is on the floor underneath right Focal monitor.
As I said, I like the results I already have with preliminary measurements and filter.
However, I was wondering if there are any suggestions or comments about maybe optimising / re-measuring this setup?
1 comment
Hey Mikey,
Thanks for your post!
If you are using a subwoofer as part of your setup, the L-R monitors will have to be routed through the sub unit. The software only supports 2.0 and 2.1 stereo systems, so the subwoofer unit(s) can't be routed separately through a third channel.
In case anyone else is looking for information on measuring your setup that includes a subwoofer, take a look at our support guide here: Measuring a subwoofer setup in 2.0 stereo